Epson FX-286 User Manual page 44

Now, run the program by typing RUN and pressing RETURN, or
print your file or document by following the printing instructions of
your software. The FX-286 prints your example in standard single-
strike printing, as shown below:
Now that you have created a sample, follow these steps to print it in
double-width mode:
1. See that both the ON LINE and READY lights are on.
2. Press the OFF LINE and FORM FEED buttons at the same time,
then release them. You hear a beep to signal that SelecType is on.
As shown in Table
3.
fore, press the OFF LINE button two times. (Remember to make
sure you hear a beep each time you press the OFF LINE button
when you are in SelecType mode.)
Now that you have selected the double-width mode, push the
4.
FORM FEED button once to set it.
5. Push the LINE FEED button once to return the panel to its standard
operation.
6. Press the OFF LINE button so the
Now you have set the FX-286 to print in double-width mode. Print
your sample once more. It should appear in double-width mode just
as you see below:
T h i s
o f F X - 2 8 6
Turn off your printer to cancel the double-width setting, and-if
you wish-try this exercise with other modes.
3-4
T h i s i s a n e x a m p l e
of FX-286 printing.
the code for double-width is two. There-
3-1,
i s a n
is ready to print.
FX-286
e x a m p l e
p r i n t i n g .