Table of Contents
Advertisement
The DIP switch settings for the Standard and Alternate sets are:
DIP
Switch
1-6
1-7
1-8
Running the self test in the IBM Proprinter mode
If you want to run a self test to see what the IBM Proprinter charac-
ter sets look like, you only have to reset DIP switch
OFF.
To run the self test, make sure the power is OFF, then hold down the
DRAFT button while turning the power switch ON-the self test
takes over and the
printer character set, as shown in Figure J-1.
Figure J-1. IBM Proprinter mode self test
If you want to see the Alternate set, turn the power OFF. Then reset
either switch
1-6, 1-7,
again.
Remember, you must also reset DIP switches
ously mentioned if you want to select the IBM Proprinter mode for
uses other than the self test.
Standard
ON
ON
ON
starts printing out the Standard IBM Pro-
FX-286
or
1-8
Alternate
Set any one of
these three
switches to OFF.
from ON to OFF, and run the self test
2-1
from ON to
1-4
and
as previ-
2-3
J-3
Advertisement
Table of Contents
