Sony Handycam CCD-TR2300 Service Manual page 44

7
[] []
[] []
[]
[]
[]
[]
[] []
[] []
[] Lighting aperture [] Viewfinder (pAl)
[] COUNTER RESET button (p.11, 38, 66) [] TIME button (p.21, 28)
[] DATE button (p.21, 28) [] AUTO LOCK/HOLD switch (p.51)
[] Lithium battery compartment (p.76) [] WHT BAL(white balance) button (p.63)
[] Tripod receptacle (p.14) [] GAIN button (p,55)
[] SHUTTER SPEED button (p.55, 57)
[] Handycam station connection
(CCD-TR3300 for Canadian model only)
(p.I8)
[] IRIS button (p.55)
[] PROGRAM AE button (p.51)
To Watch the demonstration
YOUcan watch a brief demonstration of pictures with special effects.
If the demonstration appears when you turn on the camcorder for the first time, exit the demo
mode to use your camcorder.
To enter Demo mode
(1) Remove the cassette and set the POWER switch to VTR.
(2) Turn STANDBY up.
(3) While holding down E>-, set the POWER switch to CAMERA. Demonstration starts.
If a cassette is inserted, the demo mode will stop. Note that once you enter demo mode, this mode
is retained as long as lithium battery is in place. Therefore demonstration starts automatically 10
minutes later every time you set the POWER switch to CAMERA or 10 minutes after the cassette
has been removed.
To exit Demo mode
(1) Turn the POWER switch to VTR.
(2) Turn STANBY up.
(3) While holding down CI, turn the POWER switch to CAMERA.
J.
93
94
Remote Commander
The buttons that have the same name on the Remote Commander as on the camcorder
function identically.
[] []
[]
[]
[]
[] COUNTER RESET button (p.ll, 38, 66)
[] TIME CODE WRITE button (p.71)
[] INDEX MARK (p.67)
[] DATE SEARCH button (p.65)
[] Tape transport buttons (p.19)
[] DATA CODE button (p.21)
[] ZERO MEM button (p.38, 66)
[] Transmitter
Point toward the remote sensor to control
the camcorder after turning on the
camcorder.
[]
[] HOLD switch
Slide the switch in the direction of the
arrow to prevent the buttons from being
accidentally pressed,
Before using this Remote Commander,
slide in the direction opposite to the
arrow.
[] START/STOP button (p.10,
11)
[] INDEX ERASE (p.70)
[] Power zoom button (p.12)
[] INDEX SEARCH buffon (p.68, 69, 70)
[] DISPLAY button (p.19)
To prepare the Remote Commander
To use the Remote Commander, you must insert two size AA (R6) batteries. Use the
supplied size AA (R6) batteries.
(1) Remove the battery cover from the Remote Commander.
(2) Insert both of the size AA (R6) batteries with correct polarity.
(3) Put the battery cover back onto the Remote Commander.
2