Sony Handycam CCD-TR2300 Service Manual page 41

82
On the lens
If moisture condenses on the lens, no indicator appears, but the picture becomes dim.
Turn off the power and do not use the camcorder for about 1 hour.
How to prevent moisture condensation
When bringing the camcorder from a cold place to a warm place, put the camcorder in a
plastic bag and allow it to adapt to room conditions over a period of time.
(1) Be sure to tightly seal the plastic bag containing the camcorder.
(2) Remove the bag when the air temperature inside it has reached the
temperature surrounding it (after about 1 hour).
Video
head cleaning . ..
To ensure normal recording and clear pictures, clean the video heads. When the
indicator and " I_ CLEANING CASSETTE" message appear one after another in the
viewfinder or playback pictures are "noisy" or hardly visible, the video heads may be
dirty,
[el Slightly dirty
[b] Very dirty
If this happens, clean the video heads with the Sony V8-25CLH cleaning cassette (not
supplied). After checking the picture, if it is still "noisy," repeat the cleaning. (Do not
repeat cleaning more than 5 times in one session.)
Caution
Do not use a commercially available wet-type cleaning cassette. It may damage the
video heads.
Note
If the V8-25CLH cleaning cassette is not available in your area, consult your nearest
Sony dealer.
Precautions "' i'_ i].,_: . ..... .,- .
Camcorder operation
• Operate the camcorder on 7.2 V (battery pack) or 8.4 V (AC power adaptor).
• For DC or AC operation, use the accessories recommended in this manual.
• Should any solid object or liquid get inside the casing, unplug the camcorder and
have it checked by a Sony dealer before operating it any further.
• Avoid rough handling or mechanical shock. Be particularly careful of the lens.
• Keep the POWER switch set to OFF when not using the camcorder.
• Do not wrap up the eamcorder and operate it since heat may build up internally.
• Keep the camcorder away from strong magnetic fields or mechanical vibration.
On handling tapes
Do not insert anything in the small holes on the rear of the cassette. These holes are
used to sense the type of tape, thickness of tape and if the recording tab is in or out.
Camcorder care
•. When the camcorder is not to be used for a long time, disconnect the power source
and remove the tape. Periodically turn on the power, operate the camera and player
sections and play back a tape for about 3 minutes.
• Clean the lens with a soft brush to remove dust. If there are fingerprints on it, remove
them with a soft cloth.
• Clean the camcorder body with a dry soft cloth, or a soft cloth lightiy moistened with
a mild detergent solution. Do not use any type of solvent which may damage the
finish.
AC power adaptor
Charging
• Use only a lithium ion type battery pack.
• Place the battery pack on a fiat surface without vibration during charging.
• The battery pack will get hot during charging. This is normal.
Others
• Unplug the unit from the wall outlet when not in use for a long time. To disconnect
the power cord, pull it out by the plug. Never pull the cord itself.
• Do not operate the unit with a damaged cord or if the unit has been dropped or
damaged.
• Do not bend the AC power cord forcibly, or put a heavy obiect on it. This will
damage the cord and may cause a fire or electrical shock.
• Be sure that nothing metallic comes into contact with the metal parts of the
connecting plate. If this happens, a short may occur and the unit may be damaged.
• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
* While the unit is in use, particularly during charging, keep it away from AM
receivers and video equipment because it will disturb AM reception and video
operation.
* The unit becomes warm while in use. This is normal.
• Do not place the unit in locations that are:
- Extremely hot or cold
- Dusty or dirty
- Very humid
- Vibrating
If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.
/
83