Sony Handycam CCD-TR2300 Service Manual page 38

Your camcorder is supplied with a lithium battery
installed. When the battery becomes weak or dead, the
indicator flashes in the viewfinder for about 5
seconds when you set the POWER switch to
CAMERA. In this case, replace the battery with a
Sony CR2025 or Duracell DL-2025 lithium battery.
Use of any other battery may present a risk of fire
or explosion.
The lithium battery for the camcorder lasts for about 1
year under no.rmal operation. (The lithium battery that
comes installed at the factory may not last I year.)
-_,_: JUL. 4 1996
Jl\
Note on lithium battery
The lithium battery has positive (+) side and negative (-) side as illustrated• Be sure to
insert the lithium battery with the positive side facing out.
(+) _ (-)
WARNING
The battery may explode if mistreated. Do not recharge, disassemble, or dispose of in
fire.
Caution
Keep the lithium battery out of the reach of children. Should the battery
be swallowed, consult a doctor Immediately.
Changing the lithium b';ttery
When replacing the lithium battery, keep the battery pack or other power source
attached• Otherwise, you will need to reset the date, time and other items in the menu
system retained by the lithium battery.
(1} Open the lid of the lithium battery compartment•
(2) Push the battery down once and pull it out from the holder•
(3) Install the lithium battery with the positive (+) side facing out. Close the lid.
You can set the date and time in the menu system•
(1) Press MENU to display the menu in the viewfinder.
(2) Turn the control dial to highlight CLOCK SET, and press the control dial to
select it.
(3) Turn the control dial to adjust the year, and then press the control dial.
(4) Set the month, day, hour, and minutes by turning the control dial and then
pressing the control dial.
(5) Press MENU to erase the menu display.
0
MENU
OZOOM
&E
SHIm
6EEP
YF BRIGHT
VF_.SAVE
.SLC_P ", i
[MENUlE_
e[_j .... i CLOCK SET
12 O0
IMENUI ENO
"'D}
"D}
"D:}
°DI
--.--.
CL_:KSET
....... 1,.
;kc_n S_T
• " i
:LOCK SET
To correct the date and time setting
Repeat the above procedure.
To check the preset date and time
Press DATE to display the date indicator in the viewfinder,
Press TIME to display the time indicator.
When you press the same button again, the indicator goes off.
The year indicator changes as follows: 1996 _ 1997 ......
f
Note on the time indicator
The internal clock of this camcorder operates on a 12-hour cycle•
• 12:00 AM stands h,r midnight.
• 12:00 PM stands h_r noon.
2029
f
>
o;
o
76 77