Sony Handycam CCD-TR2300 Service Manual page 4

To remove the battery pack
Slide the battery pack in the direction of the arrow.
AC-V315 AC-V316
Notes on charging the battery pack
, The CHARGE lamp will remain lit for a while even if the battery pack is removed
and the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
• When a fully charged battery pack is installed, the CHARGE lamp will light once,
then go out.
Installing the battery pack
Align the grooves of the battery pack with the receptacles of the camcorder and slide
the battery pack down until it catches on the battery release lever and clicks.
To remove the battery pack
While pressing BATY (battery) PUSH, slide the battery pack in the direction of the
arrow.
BAT'I" PUSH
1
M
Make sure that the power source is installed. When you want to record in the Hi8
system, use Hi8 video cassette Him
(1) While pressing the small blue button on the EJECT switch, slide it in the
direction of the arrow. The cassette compartment automatically lifts up and
opens.
(2) Insert a cassette with the window facing out.
(3) Close the cassette compartment by pressing the "PUSH" mark on the cassette
compartment. The cassette compartment automatically goes down.
2 3
To eject the cassette
While pressing the small blue button on the EJECT switch, slide it in the direction of the
arrow.
To prevent accidental erasure
Slide the tab on the cassette to expose the red mark. if you insert the cassette with the
red mark exposed and close the cassette compartment, the beeps sound for a while. If
you try to record with the red mark exposed, the _ and _ indicators flash in the
viewfinder, and you cannot record.
To re-record on this tape, slide the tab back out covering the red mark.
g
8 9