Assembly; Frame Assembly - Weider 2100 User Manual

ASSEMBLY
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
Before beginning assembly, carefully rend the
following Information and Instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• "13ghten a ll parts as you assemble them, unless
instructedto do otherwise.
• For help identifyingsmall parts, use the PART
The following tools (not Included) are required
for assembly:
• two adjustable wrenches
• one rubber mallet
• one standard screwdriver
• one Phillips screwdriver
• lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1.
2.
Before beginning assembly, be sure that you
have rend and understand the Information In
the box above.
Press two 50mm x 75mm Inner Caps (29) into
the sides of the Foot Plate (74).
Orient the Rear Base (3) with the indents around
the holes on the bottom. Attach the Front Base
(1) and the Rear Base to the Center Base (2) with
two M10 x 70mm Bolts (58) and two M10 Nylon
Locknuts (71).
Insert six M10 x 65mm Carriage Bolts (57) up
through the Front and Rear Bases (1, 3).
Press the three Base Caps (28) onto the ends of
the Front Base (1), the Center Base (2), and the
Rear Base. Secure the Base Caps with three M4
x 20mm Screws (77) and three M5 Washers (75).
Attach the Foot Plate (74) to the Center Base (2)
with two M10 x 65mm Carriage Bolts (57) and
two M10 Nylon Locknuts (71).
2
28
75
3
71
2
58 Indents
1
58
29
74
77
1
2
71
_75
77
-71
57 57
5