Finding A Place For The Printer - Epson Action Laser Action Laser User Manual

Finding a Place for the Printer

Setting up your printer is a simple process that takes only a few
minutes. You need to find a location for your printer and install a
few parts. Then your printer will be ready to be connected to your
computer.
Before setting up your printer, you need to find a suitable place to
use it. Be sure to keep the following points in mind when selecting a
place for your printer:
Place the printer on a flat, stable surface.
l
Place the printer close enough to the computer or workstation
l
for its cable to reach.
Your printer is equipped with four rubber feet. Be sure that your
l
printer stand or desktop is large enough to accommodate all
four feet.
Use a grounded outlet-one that has three holes to match the
l
power plug on the printer. Do not use an adapter plug.
Leave adequate room around the printer to allow easy printer
l
operation and maintenance. You need to locate a space that is 35
inches (889 mm) wide and 24 inches (610 mm) deep. When you
install the printer in this space, you should make sure there is
sufficient room
diagram for details.
Note: If you plan to install the face-up output tray, you need a
space
that
mm) deep. Within this area, you need 13 inches (330 mm) of
flat, unobstructed space to the left of the printer, rather than
the 5 inches (127 mm) shown in the diagram below. There
should be at least 2 inches (50 mm) of space to the left of the
tray after it is installed.
1-2 Setting Up the Printer
each side of the printer. See the following
on
is 44 inches (1118 mm) wide and 24 inches (610