Installing A Memory Module - Toshiba Satellite R10 User Manual

■
Use only memory modules approved by TOSHIBA.
■
Do not try to install or remove a memory module under the following
conditions. You can damage the computer and the module. Also, data
will be lost.
a. The computer is turned on.
b. The computer was shut down using the Standby mode or
c. Wake-up on LAN is enabled.
■
Be careful not to let screws or other foreign matter fall into the computer.
It could cause malfunction or electric shock.
■
Expansion memory is a precision electronic component that may be
fatally damaged by static electricity. Since human body has slight static
electricity, be sure to discharge static electricity from your body before
installing an expansion memory module. To discharge your body's static
electricity, simply touch any metal close to you with bare hands.
If you install a memory module that is not compatible with the computer,
beep will sound when you turn on the power. If the memory module is
installed in slot A, there will be a long beep (1 second) followed by two short
beeps (0.5 second each). If the memory module is in slot B, there will be a
long beep followed by four short beeps. If the both memory modules in slot
A and slot B are incompatible, there will be a long beep followed by two
short beeps and after a pause (1 second) a long beep followed by four short
beeps. In this case, shut down the power and remove the incompatible
module(s).
Be sure to install memory module to slot A. The computer does not boot
when slot A is vacant.
Use a point size 1 Phillips screwdriver to remove and fasten the screws. Use
of an incorrect screwdriver can damage the screw heads.

Installing a memory module

There are slots for two memory modules, one over the other. The procedures
are the same for installing either module.
1. Set the computer to boot mode and turn the computer's power off. Make
sure the Power indicator is off. Refer to the
in Chapter 3, Getting Started.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
Replacing the battery pack
Modes, for details.
4. Loose a screw securing the memory module cover. The screw is
attached to the cover to prevent it from being lost.
Satellite R10
Hibernation mode.
Turning off the power
section in Chapter 6, Power and Power-Up
Optional Devices
section
8-6