Toshiba Satellite R10 User Manual page 137

To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in
HDD, 2nd HDD, CD-ROM, FDD (or SD memory card), Network (LAN)
boot.
A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want and
press Enter.
■
If only a supervisor password is set.
■
■
■
If both a supervisor and a user password are set.
■
■
■
■
The selection method above does not change the boot priority settings
in HW Setup.
■
If you press a key other than one of those above or if the selected device
is not installed, the system will boot according to the current boot priority
setting in HW Setup.
Satellite R10
The menu above appear when you use the user password to start
the computer (able to run HW Setup).
The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
The menu above appear when you use the supervisor and user
password to start the computer (able to run HW Setup).
The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
The menu above appear when you use the supervisor password to
start the computer (unable to run HW Setup).
HW Setup
7-4