Wireless Communication Switch; Wireless Communication Indicator; Lan - Toshiba Satellite R10 User Manual

Wireless communication switch

You can enable or disable Wireless LAN function, with the on/off switch. No
transmissions are sent or received when the switch is off. Slide the switch
to the right to turn it on and to the left to turn it off.
■
Set the switch to off in airplanes and hospitals. Check the indicator. It
will stop glowing when the wireless communication function is off.
■
Turn the computer off when you enter an airplane and check the carrier's
regulations before you use a computer on board.

Wireless communication Indicator

The wireless communication indicator indicates the status of the wireless
communication functions.
Indicator status
Indicator off
Indicator glows
If you used the Task Bar to disable Wireless LAN, restart the computer or
follow the procedures below to enable the system to recognize Wireless
LAN. Open or click the following: start, Control Panel, System, Hardware
Device Manager, Network adapters, Intel
Connection and enable.

LAN

The computer has built-in support for Ethernet LAN (10 megabits per
second, 10BASE-T) and Fast Ethernet LAN (100 megabits per second,
100BASE-TX).
This section describes how to connect/disconnect to a LAN.
Do not install or remove an optional memory module while Wake-up on LAN
is enabled.
The Wake-up on LAN function consumes power even when the system is
off. Leave the AC adaptor connected while using this feature.
Satellite R10
Indication
Wireless communication switch is set to off.
Automatic power down because of overheating.
Power malfunction
Wireless communication switch is on. Wireless
LAN is turned on by an application.
®
PRO/Wireless-2915 Network
Operating Basics
4-35