Toshiba SATELLITE M30-35 Series Maintenance Manual page 262

4 Replacement Procedure
4. Setting bezel
1) Hook the bezel on the five latches of the frame from the upper side.
NOTE: 1)
2)
3)
(1) Install the bezel from the
TAB side. Be careful not to
damage the TAB. Hook the
bezel on the five latches.
Make sure the fold of reflector
is not outside the bezel.
Figure 4-59 Replacing TMD fluorescent lamp (WXGA) (9)
4-86
Make sure the GND-CU on the left side and lamp reflector shall be
inside the bezel.
Be careful not to damage the TAB.
Make sure the five latches of the upper side of bezel are hooked on.
Make sure the gum projection
for protecting the cable is not
outside th ebezel.
4.29 Fluorescent Lamp
Make sure the gum projection
for protecting the cable is not
outside th ebezel.
The cable shall not be
outside the bezel.
(2) Align the bezel with the
lamp side of the backlight unit.
Satellite M30-35 Maintenance Manual (960-455)