4 Replacement Procedure
5. Removing PCB-ASSY cell
1) Remove the PCB-ASSY cell from the backlight unit.
2) Remove the double-sided adhesive tape from the back of the cell.
NOTE: 1) Remove the tape slowly not to break the cell. The cell and frame are
2) Be careful not to remove the light shielding tapes from the upper left
Remove the cell by
peeling off the double-
sided adhesive tape.
Figure 4-55 Replacing TMD fluorescent lamp (WXGA) (5)
4-82
glued by double-sided adhesive tape.
and right sides of the cell.
4.29 Fluorescent Lamp
PCB-ASSY cell
Backlight unit
Satellite M30-35 Maintenance Manual (960-455)