Digital-To-Analog Converter (Dac); Pulse-Density Modulation Rate; Dac Control And Data Registers - Texas Instruments MSP50C614 User Manual

Digital-to-Analog Converter (DAC)

3.2 Digital-to-Analog Converter (DAC)
The C614 incorporates a two-pin pulse-density-modulated DAC which is
capable of driving a 32
than 32 , an external impedance-matching circuit is required.
3.2.1

Pulse-Density Modulation Rate

The rate of the master clock (MC) determines the pulse-density-modulation
(PDM) rate, and this governs the output sampling-rate and the achievable
DAC resolution. In particular, the sampling rate is determined by dividing the
PDM rate by the required resolution:
For example, a 9 bit PDM DAC at 8 kHz sampling rate requires a PDM rate of
4.096 MHz.
There are four sampling rates which may be used effectively within the
constraints of the C614 and the various software vocoders provided by Texas
Instruments. These are: 7.2 kHz, 8 kHz, 10 kHz, and 11.025 kHz. Other
sampling rates, however, may also be possible.
From the MC to the PDM clock, there is an optional divide-by-two in frequency.
This option is controlled by the PDM clock divider in the interrupt/general
control register. This means that the PDM rate can be set to run between
131.07 kHz and 33.554 MHz in 131.07 kHz steps (the same as the MC). Or,
the PDM rate can be set to run between 65.536 kHz and the maximum
achievable CPU frequency (see Chapter 8, MSP50C614 Electrical
Specifications ) in 65.536 kHz steps. The PDM clock divider determines which
of these two ranges apply. Within these ranges, it is the PLLM which sets the
rate: ClkSpdCtrl, 0x3D. Refer to Section 3.2.3, PDM Clock Divider , for more
information regarding the PDM clock divider and the available combinations
of CPU clock rates vs sampling rates. (Section 2.9.3, Clock Speed Control
Register , has more details regarding the PLLM.)
3.2.2

DAC Control and Data Registers

The resolution of the PDM-DAC is selected using the control bits in the DAC
control register (address 0x34). The available options are 8, 9, or 10 bits of res-
olution. Bits 0 and 1 in the DAC control register control this option:
3-8
loudspeaker directly. To drive loud speakers other
Output sampling rate = PDM Rate
PDM Rate
Set in ClkSpdCtrl register
Address 0x3D
(# DAC resolution bits)
2
#DAC resolution bits
Set in DAC control register
Address 0x34