Robin America R1700i Service Manual page 37

5-4-21 Case body, control panel
Attach the case body (left and right). Install the bottom
part of the case body and the mount together.
M6 x 18mm Flange bolt : 4pcs.
Tightening torque : 3.0-4.0
NOTE: Install the bottom part of the case body
correctly.
Attach the upper part of the case body.
M6 x 25 Screw and Washer : 2pcs.
Tightening torque : 3.0-4.0
NOTE: Avoid gaps in the upper part of the case body
when installing.
Install the control panel into the case body.
M4 x 14mm Screw 4pcs.
M5 x 8mm Screw 4pcs.
Tightening torque : 2.0-3.0
5-4-22 Recoil starter and guide
Install the guide of the starter hundle.
Install the guide and starter hundle after they are
pushed through the mounting hole from inside of the
case body.
M4 x 10mm Tapping screw : 1pcs.
Insert the overflow pipe through the hole in the bottom
of the case body.
N m
30-40 kgf cm
(2.2-2.9 ft lbs)
N m
30-40 kgf cm
(2.2-2.9 ft lbs)
N m
20-30 kgf cm
(1.5-2.2 ft lbs)
Case body
Recoil starter
hundle
Guide
Overflow pipe
– 34 –
Mount
Case body
Control panel