Robin America R1700i Service Manual page 33

5-4-9 Rotor
Install the rotor.
M6 x 20mm Flange bolt : 3pcs.
Tightening torque : 10.0-12.0 N m
<CAUTION>
The stator and the rotor are pulling each other by a
strong magnetic force. Please use care when
assembling the stator close to the rotor.
Carelessness may cause injury such as smashing a
finger.
NOTE : Avoid damaging the magnet of the rotor.
5-4-10 Rear cover, stator
Install the rear cover of the generator and stator into the
rotor.
NOTE: The rotor and the stator are pulling each
other by a very strong magnetic force.
Make sure the rotor does not have foreign
substances on it, and fingers are not
smashed when installing.
Install the rear cover to the blower housing.
M6 x 25mm Flange bolt : 3pcs.
Tightening torque : 10.0-11.0 N m
NOTE: Make sure of the direction of rear cover
during installation.
100-120 kgf cm
(7.4-8.9 ft lbs)
100-110 kgf cm
(7.4-8.1 ft lbs)
– 30 –
Rotor
Rotor
Rear cover
Stator
Rear cover