Table of Contents
Advertisement
5-3-4 Remove the recoil starter handle
Remove the recoil starter guide connected to the case
body (left).
Push the guide and the starter hundle through the hole
which the case body (left) guide was attached.
M4 x 10mm Tapping screw
Tools : Screw driver
5-3-5 Remove the control panel (1)
Remove the control panel from the case body.
M4 x 14mm Screw 4pcs.
M5 x 8mm Screw 4pcs.
Tools : Screw driver
NOTE: At this point, the couplers of electrical wires are
connected to the control panel. Instead of
removing the control panel forcibly, remove it
after disassembling the case body and fuel tank.
5-3-6 Remove the case body (Left, Right)
Remove the case body (Left, Right)
Remove the plastic pipe from the case body.
(Overflow pipe)
Upper part of the case body
M6 x 25mm Screw and Washer : 2pcs.
M6 x 20mm Screw and Washer : 1pce.
M4 x 110mm Screw : 1pce.
Tools : Screw driver
Bottom part of the case body
Remove the case with the mount still fastened to it.
M6 x 18mm Flange bolt : 4pcs.
Tools : 10mm Box wrench
1pce.
– 20 –
Recoil starter
hundle
Guide
Overflow pipe
Case body
Case body
Control Panel
Mount
Hide quick links:
Advertisement
Table of Contents
