Table of Contents
Advertisement
4-4. Setup – DEVICE
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.
Navigate through the menu items using the mouse or the control button on the remote control and change
the value of the menu item.
Item
ALARM OUT
CONTROLLER & PTZ
CHANNEL
SPOT OUT
MOTION ZONE
MOTION SENSITIVITY
KEY TONE
REMOTE CONTROL ID
Figure 4.4.1. Device Mode Setup Screen
Table 4.4.1. Menu Items in Device Setup Screen
Set the sensor, motion, and video loss for triggering alarm relay.
HDD Error and Video Loss can trigger beeping.
Set the PTZ baud rate, protocol, and ID.
Select specified channel for motion zone setup.
Set the spot out
Select either Full Zone or Partial Zone for motion sensing.
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
Enable/disable key tone.
Select an ID of remote control.
1. Select ID number.
Description
28
Advertisement
Table of Contents
