Table 1-2 Description Of The Respective Board Parts - Fujitsu FR Family FR60 Lite User Manual

"Table 1-2 Description of the respective board parts" provides descriptions of the respective board parts.
No. Name
(1) Target device
(2) Target device oscillator
(3) CAN transceiver
(4) CAN connector
(5) USB to UART converter
(6) USB connector
(7) Motor driver circuit
(8) Motor connector
(9) DC jack
(10) Mode SW
(11) Reset SW
(12) Test switches
(13) LED lamps
(14) Temperature sensor
(15) Fuse
(16) Extension pins
(17) Jumper pins (JP1, JP2)

Table 1-2 Description of the respective board parts

Function
MB91F267N
CSTCR4M00G15C
MAX3058ASA+
3-pin connector
FT232RL
miniB
3-phase motor driver
circuit
8 pins
-
Slide switch
Push switch
Push switch x 2
Slide switch x 1
LED (green) x 6
LED (red) x 3
NTCG164BH103
0217001P
-
-
- 15 -
Description
Main microcontroller (MB91F267N).
Ceralock made by Murata Manufacturing
Oscillator for the main microcontroller.
Transceiver IC for CAN communication.
Connector for CAN communication.
Connect this connector to the CAN connector on the
bits pot white.
IC for conversion between UART and USB.
USB connector for connection with the PC to
write/debug a program.
Driver circuit for 3-phase motor operation by the main
microcontroller.
Connector for connection with the 3-phase motor
included in the kit.
Power connector for the operation of the motor.
Switch for selection of operation mode of the board.
Switch to reset the board.
Connected to the general-purpose I/O port.
The sample program uses this switch for motor rotation.
General-purpose LED lamps.
NTC thermistor made by TDK
Temperature sensor connected to the A/D converter.
Fuse for the 12-V power supply.
Extension pins of the main microcontroller.
For details, see the circuit diagram.
Jumper pins for USB-UART conversion setting.
UART communication handshake setting.
1-2: Handshake by software.
2-3: Handshake by hardware.
The default setting is 2-3 (common to JP1/JP2).
AN07-00180-3E