Table of Contents
Advertisement
CHAPTER 8 PULSE WIDTH COUNT TIMER (PWC)
8.7
Operation of Noise Filter Circuit
This section describes the operations of noise filter circuit function when the pulse
width measurement function is selected.
I Operation of noise filter circuit function
Figure 8.7-1 "Noise filter circuit function settings" shows the settings required to operate as the noise filter
circuit function.
NCCR
When pulse width measurement function is selected, the noise filter circuit can be used to clear the noise.
By the selecting different value for sampling clock pulse selection bit (NCS1 and NCS0) of noise filter
control register (NCCR), different kind of the noise can be filtered out. Integrating the sampled signal
clears the noise. The maximum width of the cleared noise is as follows:
N
= sampling clock cycle x 5
W
When noise clearing is prohibited, the PWC input is input directly to PWC counter/timer.
Figure 8.7-2 "Operation of noise filter circuit function" shows the operation of the noise filter circuit.
PWC input
Sampling
clock
pulse
Integrated
value
Internal
signal
162
Figure 8.7-1 Noise filter circuit function settings
Bit 7
Bit 6
Bit 5
Figure 8.7-2 Operation of noise filter circuit function
Bit 4
Bit 3
Bit 2
Bit 1
NCS1
Bit 0
NCS0
: Unused bit
: Used bit
Advertisement
Table of Contents
