Chapter 6 Embroidering
1.
2.
3.
158
When "Semi-wide cap (All)" is selected
Thread Trimming
The following items can be set:
Enable inching
Hoop movement after
thread trimming
Thread length
(1-10) for all machines
Thread length after
thread trimming
Select [Thread Trimming] from Settings menu.
Set inching, thread length, etc.
Click [OK].
BES-940BC • BES-1240BC
The image is displayed upside down.
The speed is automatically adjusted to
800 rpm or less.
Sets inching motion for thread trimming.
Sets the needle penetration length for trimming.
The length can be set in inches. To set the length in inch
unit, select [Inch] from the [Configuration] of Tool menu.
The available values are as follows:
For mm
0 - 100 mm (The standard value is 15 mm.)
For inch
0 - 3.9 inch (The standard value is 0.6 inch.)
Sets the overall thread amount through the needle.
Value of 1 to 10 can be set. The smaller the value is, the
shorter the length is.
Sets the overall thread amount through the needle.
Value of 1 to 10 can be set. The smaller the value is,
the shorter the length is.