Brother BES-1240BC Instruction Manual page 34

Chapter 2 Preparation of Embroidery Machine
BES-1240BC
y
1. Remove 3 pieces of fixing screw q, loosen 2 pieces of screw w and remove the color change
cover e.
2. Remove the bolts r and detach the fixing bracket for transportation from the bridge and the
connecting shaft.
3. Loosen the bolts t and set screw !0 , and move the needle bar case y left side.
4. Press the change bracket collar i against the change case base u, while pressing the left side
change bracket collar o against the change case base u, and tighten the bolts t and set
screw ! 0 . Check that needle bar No.1 and 12 are inserted into the needle plate holes smoothly.
Notes) • Check that ther is no play for the connecting shaft in the horizontal direction.
• Never loose the bolt of the change bracket coller i. If this bolt is loosened, the change bracket coller
i will be dislocated and the position of the needle bar case y will need to be adjusted.
5. Attach the color change cover e by 3 pieces of fixing screw q and 2 pieces of fixing screw w.
6. Attach the linear guide cover ! 1 by 2 pieces of tightening screw ! 2 .
32
r
!1
o
t
o
o
q
u
e
BES-940BC • BES-1240BC
Bridge
Connecting shaft
Fixing bracket
Fixing bracket B
!2
q
!0
i
w