Brother BES-1240BC Instruction Manual page 36

Chapter 2 Preparation of Embroidery Machine
t
(A)
4. Mount four drilling bolts i, four spring washers ! 0 , and four flat washers ! 1 respectively at
the rear of F tables R t, M y, and L u.
5. Mount five thumb bolts on the steel pipe below the front leg.
6. Insert the pins attached to the rear of the F table R t, M (2 pcs.) y, and L u into the cover o
on the leg. Adjust the height of the F table guide U q and the F table support F e so that the
table top surface will become 1 mm lower than the bed top surface. After adjustment is
finished, tighten each bolt securely.
7. Mount a drilling bolt i, a spring washer !0 , and a flat washer !1 in section (A) of F tables R t
and L u.
34
i
y
Lower by 1 mm
BES-940BC • BES-1240BC
(A)
u
q
e
o
Pin