Table of Contents
Advertisement
Embroidering
IMPORTANT
• When adjusting the bobbin case, be sure to
remove the bobbin from the bobbin case.
• DO NOT adjust the position of the phillips (+)
screw on the bobbin case as this may result in
damage to the bobbin case, rendering it
unusable.
• If the slotted-head screw (-) is difficult to turn,
do not use force. Turning the screw too much
or providing force in either (rotational)
direction may cause damage to the bobbin
case. Should damage occur, the bobbin case
may not maintain proper tension.
Using the automatic thread cutting function
(End Color Trim)
The automatic thread cutting function will cut the thread at
the end of embroidering each color. This function is initially
turned on. To turn this function off, touch
.
a
Touch
.
b
Touch
to turn off the automatic thread cutting
function.
The key will display as
• When one color thread is embroidered, the machine
will stop without cutting the thread.
c
Touch
to return to the original screen.
38
Using the thread trimming function (Jump
Stitch Trim)
The thread trimming function
excess thread jumps within the color. This function is initially
turned on. To turn this function off, touch
.
• Embroidery frame (small) 2 cm (H) × 6 cm (W)
(1 inch (H) × 2-1/2 inches (W)) (sold separately)
cannot be used.
Thread trimming function will be cancelled if either
[Embroidery Frame Identification View] is [ON] and
the embroidery frame (small) is selected or a pattern
that will fit in the embroidery frame (small) is
selected.
key and then
• When using the thread trimming function, do
not use embroidery frame (small). Otherwise,
the presser foot may strike the frame, possibly
causing injuries or damage.
■ Selecting the Length of Jump Stitch Not to Trim
When the thread trimming function
can select the length at which jump stitch trimming starts.
* Your customized setting remains after turning the
machine off and on.
Touch
For example: Touch
machine will not trim a jump stitch of 25 mm or less
before moving to the next stitching.
• If a design has many trims it is recommended to
select a higher jump stitch trim setting in order to
reduce the amount of excess tails on backside of
fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the machine
will trim. In this case, more jump stitches will
remain on the surface of the fabric.
will automatically trim any
CAUTION
or
to select the length of jump stitch.
to select 25 mm (1 inch) and the
Memo
key and then
1 Jump stitch
is turned on, you
Advertisement
Table of Contents
