Demo Mode; Restore Factory Defaults - Lexmark M410 - Optra B/W Laser Printer Service Manual

4045-XXX
To disable the Download Emulation:
1. Select Download Emuls from the CONFIG MENU.
2. Select Disable.
The printer automatically exits the Configuration Menu Group and
initializes as if the Download Emulator were not installed. Once the
printer is idle, a new Emulator can be downloaded again.
Note: If the user power cycles the printer after selecting the Disable
option, the Downloaded Emulator will be reactivated.

Demo Mode

The Demo Mode setting is used to remember whether or not demo
mode is active. If the Demo Mode setting is set to On, then demo
mode is entered each time the printer is powered on. If the Demo
Mode setting is set to Off, then normal mode is entered each time
the printer is powered on.
To Activate/Deactivate Demo Mode:
1. Select Demo Mode from the CONFIG MENU.
2. Press the Menu button to locate Activate or Deactivate.
3. Press the Select button to store your selection.

Restore Factory Defaults

This operation will the restore factory default values for most printer
settings.
WARNING: Extreme care should be used when using this operation
as it cannot be undone.
To Restore Factory Defaults:
1. Select Factory Defaults from the CONFIG MENU.
2. Select Factory Defaults=Restore All.
The actual restoration of the factory default values occurs upon
exiting of the CONFIG MENU.
3-4
Service Manual