Diagnostic Information; Start - Lexmark M410 - Optra B/W Laser Printer Service Manual

4045-XXX

2. Diagnostic Information

Start

CAUTION: Remove power from the printer before you connect or
disconnect any cable or electronic board or assembly for personal
safety and to prevent damage to the printer. Use the handholds on
the side of the printer. Make sure your fingers are not under the
printer when you lift or set the printer down.
Use the service error code, user status message, user error
message, symptom table, service checks, and diagnostic aids in this
chapter to determine the corrective action necessary to repair a
malfunctioning printer.
Service error codes are indicated by a three-digit error code. If a
service error code is displayed, go to the
page 2-2.
User status messages provide the user with information on the
current status of the printer. Ready is displayed on the first line of the
display unless Power Saver is invoked, and then Power Saver is
displayed. If a user status message is displayed, go to the
Status Messages" on page
User error messages are indicated by a two or three-digit error code
that provides the user with information that explains a problem with a
print cartridge, paper jam, option, port, and so on. If a user error
message is displayed, go to the
If your machine completes the without an error, and you have a
symptom, go to the
symptom and take the appropriate action.
If a service error code appears while you are working on the
machine, go to the
indicated action for that error.
2-5.
"User Error Messages" on page
"Symptom Tables" on page
"Service Error Codes" on page 2-2
"Service Error Codes" on
2-15. Locate your
and take the
Diagnostic Information
"User
2-9.
2-1