User Error Messages - Lexmark M410 - Optra B/W Laser Printer Service Manual

4045-XXX

User Error Messages

User Error Message
200 Paper Jam
Remove Cartridge
201 Paper Jam
Remove Cartridge
202 Paper Jam
Open Rear Door
203 Paper Jam
Short Paper
250 Paper Jam
Check MP Feeder
Insert Cartridge or Close
Door
34 Short Paper
35 Res Save Off
Deficient Memory
37 Insufficient Collation
Memory
38 Memory Full
Explanation
Paper is jammed at the printer Input Sensor.
Open the printer's upper front door and remove
the print cartridge to access the paper jam area.
Paper is jammed between the printer's input and
exit sensors. Open the printer's upper front door
and remove the print cartridge to access the jam
area.
Paper is jammed at the printer exit sensor. Open
the printer rear door to access the jam area.
Paper stops behind the rear door when feeding to
the top output bin. Paper or envelopes that are
shorter than 6.2 inches (157.5 mm) in length must
exit through the rear exit.
Paper is jammed in the multipurpose feeder.
This message displays when the printer's front
door is open or the print cartridge is missing.
If this message cannot be cleared go to
Open Switch/Cable Service Check" on page
The printer determines the paper length is too
short to print the formatted data. This occurs
when the printer does not know the actual paper
size loaded in the tray. For auto-size sensing
trays, this error occurs if the paper stop is in the
incorrect position. Make sure the Paper Size
setting is correct for the size paper that is being
used.
This message displays when the printer has
insufficient memory to enable Resource Save.
Modification of user settings that use memory can
cause this error.
This message is displayed when the printer
memory used to store pages is too full to collate
the print job.
This message is displayed when the printer
memory used to store pages is full.
Diagnostic Information
"Cover
2-19.
2-9