Installing The Network Expansion Module - Enterasys Gold Distributed Forwarding Engine 4G4282-49 Hardware Installation Manual

Installing Optional Network Expansion Modules
Figure 3-2
1 Screw (1)
2 Main bo\ard
3 Standoff
2. Use the two saved coverplate screws to fasten the network expansion module to the
DFE‐Gold module front panel. Do not tighten the two coverplate screws at this time.
3. Use the saved screw from the standoff to fasten the network expansion module to the
standoff. Tighten the screw.
4. Tighten the two front‐panel coverplate screws.
5. This completes the network expansion module installation. To install Mini‐GBICs into
the network expansion module, proceed to "Installing an Optional Mini‐GBIC" on
page
Placement and Rules" on page 3‐9 to install the DFE module into the chassis.
3-4 Installation

Installing the Network Expansion Module

Ä
Ç
4 Optional expansion module
5 DFE-Gold module
6 Expansion module connectors
3‐5 for the Mini‐GBIC installation instructions. Otherwise, proceed to "Module
Å
Ã
front panel
À
Â
Á
Æ
7 Main board connectors
8 Coverplate screws (2)