Clock And Timer; Power Outage - GE JBP80 Use And Care & Installation Manual

Electric range with convection oven
Table of Contents

Advertisement

OVEN
CONTROL,
CLOCK
AND TIMER
Clock
The clock must be set for the
automatic
oven timing functions
to
work properly. The time of day
cannot be changed during a Timed
Baking or CLEAN cycle.
To Set the Clock
]
1. Press the
CLOCK
CLOCK
pad.
2. Press the INCREASE
or
DECREASE
pad to set the
time of day.
3. Press the CLOCK
pad to start.
Timer
The timer is a minute timer; it does
not control oven operations.
The
maximum
setting on the timer is
9 hours and 55 minutes.
To Set the Timer
1. Press the
TIMER
TIMER pad.
2. Press the INCREASE
or
DECREASE
pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE
pad.
The timer, as you are setting it,
will display hours and minutes.
"HR" will be in the display.
During the countdown,
when the
timer reaches the last minute, the
display will change to seconds
only aim a single beep will sound.
To Reset the Timer
If both "SET" and "TIMER"
are displayed,
press the
INCREASE
or DECREASE
pad until desired time
is reached.
If only "TIMER"
is displayed,
press the TIMER pad
first, then follow the instructions
above to set the timer.
To Cancel the Timer
Press and hold the TIMER pad until the word
"TIMER"
disappears
from the display.
End of Cycle Tones
The end of cycle tone is a series of 3 beeps followed
by 1 beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds, press
and hold the CI_EAR/OFF
pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR!OFF
pad for 10 seconds.
Power Outage
After a power outage, when power is restored,
the
display will flash and time shown will no longer be
correct-for
example,
after a 5-minute
power
interruption
the clock will be 5 minutes slow.
All other functions
that were in operation
when the
power went out will have to be programmed
again.
Display
Messages
programmed
information
can be
displayed
at any time by pressing
the pad of the operation
you want
to see. For example, you can
display the current time of day
while the timer is counting
down
by pressing
the CLOCK pad. Press
the TIMER pad to return to the
timer display.
To check the start time for Delayed
Bake or Self-Clean,
press and hold
the COOK TIME or AUTO SELF
CLEAN pad for 3 seconds. The
display will show the bake or clean
start time for as long as you press
the pad. When you release the pad,
the display will return to the time
of day.
If "door" appears in the display,
LOCK flashes, and the oven
control signals you set the self-
clean cycle and did not shut the
oven door.
(continued
imxt page_
19
r_
¢'1
©
.,a
m,._,

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jbp95Jbp90

Table of Contents