Door Removal; Oven Light - GE JBP80 Use And Care & Installation Manual

Lift-Off Oven Door
The oven door is removable,
but it is heavy. You may need help
removing and replacing the door.
Do not lift the door by the handle.
This can cause the glass to break
or can cause damage to the door.
To remove the door, open it a few
inches to the special stop position
that will hold the door open. Grasp
firmly on each side and lift the
door straight up and off the hinges.
NOTE: Be careful not to place hands between the
hinge and the oven door flame as the hinge could
snap back and pinch fingers.
To replace the door, make sure the hinges are in the
special stop position. Position the slots in the bottom
of the door squarely over the hinges. Then lower the
door slowly and evenly over both hinges at the same
time. If hinges snap back against the oven flame, pull
them back out.
TO CLEAN THE DOOR:
Inside of the door:
• Because the area inside the gasket is cleaned during
the self clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional
stains when the oven is heated.
• The area outside the gasket can be cleaned with a
scouring pad.
• Do not rub or clean the door gaske_the fiberglass
material of the gasket has an extremely low
resistance to abrasion. An intact and well-fitting
oven door gasket is essential for energy-efficient
oven operation and good baking results. If you
notice the gasket becoming worn, flayed or damaged
in any way or if it has become displaced on the door,
you should have it replaced.
NOTE: The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Inside Gasket
Gasket
| I
Outside of the door:
.Use soap and water to thoroughly clean the top,
sides aud front of the oven door. Rinse well. You
may also use a glass cleaner to clean the glass on
the outside of the door.
• Spillage of marinades, fruit juices, tomato sauces
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.
•Do not use oven cleaners, cleansing powders or
harsh abrasives on the outside of the door.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electric power for your range at the
main fuse or circuit breaker panel or pull the plug.
Be sure to let the light cover and bulb cool completely
before removing or replacing them. When in use, light
bulbs can become warm enough to break if touched
with a moist cloth or towel. When cleaning, avoid
touching warm lights with cleaning cloths if the light
cover is removed.
The oven light (bulb) _
is covered
with a
removable _i//_a_
glass cover which is held in
place with a wire. Remove the
oven door, if desired, to reach
the cover easily.
Wire Cover Holder
To remove: Hold your hand under the cover so it
doesn't fall when released. With fingers of the same
hand, firmly push back the wire cover holder. Lift off
the cover.
DO NOT REMOVE ANY SCREWS.
•Replace bulb with 40-watt home appliance bulb.
To replace cover:
•Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
• Connect electric power to the range.
(contim¢ed next page)
45
¢'
mllll