GE JBP80 Use And Care & Installation Manual page 53

PROBLEM
OVEN DOOR
ACCIDENTALLY LOCKED
DURING COOKING
OVEN DOOR WILL
NOT UNLOCK
OVEN DOOR IS CROOKED
POSSIBLE CAUSE
• Press the CLEAR/OFF pad. Allow the range to cool to room temperature
and reset the controls.
• The oven must cool below the locking temperature•
• Because the oven door is removable, it sometimes gets out of position during
installation• To straighten the door, push down on the high corner•
OVEN NOT CLEAN
.The oven controls are not set properly.
AFTER CLEAN CYCLE
.Heavily soiled ovens may need to self-clean again or for a longer period.
.Heavy spil!oversshould be cleaned before starting clean cycle.
"door' 'APPEARS
IN THE DISPLAY
• The self-clean cycle has been selected but the latch handle was not moved
all the way to the right. Move the latch handle.
•The latch handle was moved to the right but another program other than
self-clean was selected. Move latch handle to the right only when setting
self-clean cycle.
CONTROL SIGNALS AFTER ,This is reminding you to enter a bake temperature•
ENTERINGOVENTIME
OR STOP TIME
Electric Coil Models
SURFACE UNITS . Surface units are not plugged in solidly•
NOT FUNCTIONING ,Drip pans are not set securely in the cooktop.
PROPERLY
•Surface unit controls are not properly set.
Glass Cooktop Models
SURFACE UNITS WILL NO_
MAINTAIN A ROLLING
BOIL OR FRYING RATE IS
NOT FAST ENOUGH
COOKTOP FEELS HOT
SURFACE UNITS DO NOT
WORK PROPERLY
•You must use pans which are absolutely flat. If light can be seen between the
pan bottom and a straight edge, the surface units will not transfer heat properly.
• Pan bottoms should closely match the diameter of the surface unit selected.
•The cooktop glass surfaces may seem hotter than you are used to.
This is normal. Make sure flat-bottomed pans are used.
.Difficulty may be in the main distribution panel of your house, caused by a
blown oven-circuit fuse, a tripped oven-circuit breaker, the main fuse or the
main circuit breaker, depending on the nature of the power supply. If a circuit
breaker is involved, reset it. If the control box uses fuses, the oven fuse
(a cartridge-type) should be changed, BUT ONLY BY SOMEONE FAMILIAR
WITH ELECTRICAL CIRCUITS. If after performing one of these procedures,
the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should ask their building
management to perform this check before calling for service.
° If the range is connected to 208 volts, you will notice some increase in
cooking times.
•The cooktop surface unit controls are not properly set, or the wrong control
knob is set for the surface unit you are using.
(continued nt xt page)
53
m
'I
m
m
F