Log Placement (13 Log Set) - Empire Comfort Systems DVX36DP31(N,P)-1 Installation Instructions And Owner's Manual

Before you begin: If you are installing logs into the DVX36 or
DVX42 model then this fireplace is supplied with a set of 13
ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please refer
to Figures 63 through 66 and corresponding WARNING, when
completing the following log placement steps.
1. Remove front. See Page 61.
2. Remove glass door from firebox.
3. Remove logs from bun.
4. Place Rear Bottom Log (A) on the rear part of the burner over
the pilot.
5. Place Rear Top Log (B) on log shelf on burner ensuring pins
go into holes on bottom of log.
Page 40

LOG PLACEMENT (13 LOG SET)

6. Place Bottom Left Log (C) on far left pin of burner. The "lip"
of the log will hang off the side of the burner.
7. Place Bottom Left Center Log (D) on second and third pins
from left side of the burner.
8. Place Bottom Right Center Log (E) on fourth and fifth pins
from the left side of the burner.
25613-0-0309