Table of Contents
Advertisement
7.17 I would like to reduce the image noise (Noise Reduction)
This function enables visual presenter to automatically clear image noise. The noise is especially obvious when Visual
presenter is connected to a DLP projector. You can use this function to improve the image quality.
1. Press [Menu] on the remote control or control panel to enter the setting menu.
2. Press [] or [] to the [Setting].
3. Press [] to find [Noise Reduction].
4. Press [] or [] to select [On].
7.18 I would like to set / change the password (Lock Down)
7.18.1 Setting the password
1. Press [Menu] on the control panel to enter the setting menu.
2. Press [] or [] to the [Advance] menu.
3. Press [] to [Lock Down].
4. Press [] or [] to select [On].
5. The screen will be displayed, as shown below.
6. Key in the password
Press the keys on the control panel. All keys can be used as part of the password except the [Power] and [Enter]
keys. The maximum number of characters is 2. For example, you can press [Source] + [Menu] as the
password.
<Remark>The screen will show * while you enter the password. Ensure that you remember the order in
which the keys are entered.
7. After completing the password, press [Enter].
8. The confirmation screen will be displayed, as shown below. Enter the password again.
9. After you enter the password, press [Enter].
If the password is entered correctly, setup is completed. If the password is incorrect, an error message is
displayed and please follows the screen instructions.
7.18.2 Changing the password
1. Press [Menu] on the control panel to enter the setting menu.
2. Press [] or [] to the [Advance] menu.
3. Press [] to [Lock Down]
4. Press [] or [] to select [Off] and deactivate the password setting function.
5. Press [] or [] to select [On] and reactivate the password setting function. Refer to Steps 5-8 in
would like to set / change the password
Key in Password
Confirm password
for operational steps.
445 7.18 I
English - 24
Advertisement
Table of Contents
