Installation - Cornelius UC 701 SERIES Installation And Service Manual

1. Keep unit in the upright position, remove carton and pallet from the Icemaker and inspect for damage. If any
damage is found, file a claim with carrier immediately.
2. Locate startup card either on outside of container or on plastic liner. Fill in proper information and send one to
factory, and other copy to distributor. Postage is prepaid.
3. Install the Dispenser first, following installation instructions supplied with the Dispenser.
4. Remove the two hole plugs from the side of the dispenser.
A. The plugs are pressed in and sealed with a silastic sealant. To remove pry the outside cap off and then
press the inside plug into the bin. Discard both plugs.
B. Install the icemaker alignment brackets (Supplied with icemaker) to the dispenser (See Figure 2).
5. Install the Icemaker:
A. Install the icemaker alignment brackets (Supplied with icemaker) to the icemaker (See Figure 2).
B. Roll the Icemaker into the cabinet alongside the Dispenser.
C. Level and align the icemaker to the dispenser using the four level adjustment bolts located on the lower
front of the Icemaker.
D. Install the locking bolt on the lower front of the icemaker.
E. Connect drain, power and water.
6. Install transport tube:
A. Insert the ice transport tube through the bin into the transport elbow on the Icemaker. (Note
equipped with a safety switch located at the base of the elbow, this switch will prevent the icemaker from running if the elbow is not
properly installed ).
B. Align the nylon lock screw on the elbow with the recess on the tube. Install lock screw.
7. Connect bin thermostat:
A. Locate bin thermostat cable supplied with the icemaker (Black cable) and connect to electrical box on the
UC700 and the receptacle on the side of the dispenser.
© 2000-2012, IMI Cornelius Inc.
UC 701 Series Continuous Flow Icemaker Installation and Service Manual

INSTALLATION

Figure 2. Side Bracket Installation
- 7 -
: The icemaker is
Publication Number: 630460150