Installation Instructions; Countertop Installation - Cornelius PR150 BC Operator's Manual

The profile ice/drink dispenser

Hide thumbs Also See for PR150 BC:

Operator's manual (32 pages)

Operator's manual (4 pages)

Table Of Contents

Table of Contents

COUNTER HEIGHT

(INCHES)

34--1/2

COUNTERTOP INSTALLATION

IMPORTANT: It is the responsibility of the installer to ensure that the drains from the dispensing

equipment is installed and maintained according to Federal, State, and local laws.

1. Locate the dispenser indoors on a level countertop.

The dispenser must be sealed to the countertop. The MOUNTING TEMPLATE (see Figure 1) indicates the

opening that must be cut in the countertop. Locate the desired position for the dispenser, then mark the

outline dimension on the countertop using the dimensions given or use the full size template enclosed.

Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent) approxi-

mately 1/4 inch inside the dispenser outline dimensions and around all openings. Position the dispenser on

the countertop within the outline dimensions. All excess sealant must be wiped away immediately.

2. The drain tube is routed through the large opening in the bottom of the dispenser. See the MOUNTING

TEMPLATE (see Figure 1) for locating the required clearance hole in the countertop for these utility lines.

The power cord is routed through hole in the side of the dispenser electrical control box.

3. SINK DRAIN ASSEMBLY: Connect the drain tube to an open drain. Additional drain tubing is provided with

the Dispenser. The drain tube must continuously pitch downword and contain no "traps" or improper drain-

age will result.

Use 3/4--inch nominal plastic pipe.

To assure proper drainage, do not allow a "trap" to form in the drain line. Be sure drain line runs flat

with bottom of the dispenser.

IMPORTANT: This dispenser must be installed with adequate backflow protection to comply with

Federal, State, and Local Codes.

4. Clean the hopper interior (See CLEANING INSTRUCTIONS).

5. Connect dispenser power cord to 120 VAC 60 HZ 15--Amp 3--wire grounded receptacle.