Panasonic HDC-Z10000P Owner's Manual page 59

∫ Using an external microphone or audio equipment
≥ Set [MIC SETUP] to [2ch]. (l 57)
1
Connect an external microphone or audio
equipment to AUDIO INPUT1,2 terminals
(XLR 3 pin). (l 15)
2
Use INPUT1,2 (LINE/MIC) switches to
switch the connected audio input signal.
LINE: audio equipment is connected
Input level is 0 dBu.
MIC: an external microphone is connected
Input level is -50 dBu.
≥ When [EXT. MIC GAIN1] or [EXT. MIC GAIN2] is set to
[-60dB], the input level is set to -60 dBu. (l 121)
3
(When using the phantom microphone (which
requires +48 V power supply))
Set the INPUT1,2 (+48V) switches to ON.
ON: +48 V power supply to audio input terminals 1, 2 (XLR 3 pin).
OFF: No power supply for audio input terminals 1, 2 (XLR 3 pin).
4
Use the CH1 switch to select the input signal to be recorded to audio
channel 1.
INT(L): Audio from the built-in microphone L (left) ch is recorded to audio channel 1.
INPUT1: Audio from a device connected to audio input terminal 1 (XLR 3 pin) is recorded to
channel 1.
INPUT2: Audio from a device connected to audio input terminal 2 (XLR 3 pin) is recorded to
channel 1.
5
Use the CH2 switch to select the input signal to be recorded to audio
channel 2.
INT(R): Audio from the built-in microphone R (right) ch is recorded to audio channel 2.
INPUT2: Audio from a device connected to audio input terminal 2 (XLR 3 pin) is recorded to
channel 2.
A AUDIO INPUT2
terminal (XLR 3 pin)
B AUDIO INPUT1
terminal (XLR 3 pin)
59
VQT3U98