Sound Setting
Rotary encoder
/ENTER
AUDIO/SETUP
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press AUDIO repeatedly to choose the desired mode.
Each press changes the mode as follows:
*1
BASS LEVEL
SUBWOOFER
FADER DEFEAT VOLUME SUBWOOFER
When the subwoofer mode is set to OFF, its level cannot be
adjusted, refer to "Turning Subwoofer ON/OFF" on page 18.
Adjustable only when DEFEAT is OFF.
Subwoofer
Bass level
Treble level
Balance
Fader
Defeat
Volume
Note
• If no operation is performed for 5 seconds, the unit automatically
returns to normal mode.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted level settings of BASS
and TREBLE will return to the factory defaults.
Preset buttons
(1 through 6)
*2
*2
TRE LEVEL
BALANCE
+0 ~ +15
−7 ~ +7
−7 ~ +7
L15 ~ R15
R15 ~ F15
ON/OFF
0 ~ 35
Sound Setting
You can flexibly customize the unit to suit your own preference and
usage. From the AUDIO SETUP menu, Audio Setting can be modified.
Use steps 1 to 5 to select the category you wish to modify. For
details on how to change each setting, see the following
sections below.
1
Press and hold AUDIOSETUP for at least 2 seconds to
activate the SETUP mode.
2
Turn the Rotary encoder to select AUDIO, and then press
ENTER.
*1
GENERAL DISPLAY TUNER SIRIUSXM
AUDIO
IPOD&USB APP BLUETOOTH AUDIO
Adjustment cannot be performed during phone call.
Displayed only when a SiriusXM Tuner is connected.
(CDE-HD148BT only)
3
Turn the Rotary encoder to select the desired sound
setting menu, and then press ENTER.
*3/*4
9BAND P-EQ
FACTORY EQ
SUBWOOFER SUBW PHASE
*3
*3
LENGTH
MX SETTING
FACTORY EQ
Adjustment cannot be performed when DEFEAT is set to ON.
Any changes made to either FACTORY EQ or 9BAND P-EQ are
reflected in the others' settings.
In step 3, after selecting a Band (BAND1 to BAND9) from
9BAND P-EQ adjustment mode, turn the Rotary encoder to
select the desired item, and then press ENTER to continue to
step 4.
These functions are inoperable when Subwoofer is set to OFF.
4
Turn the Rotary encoder to change the setting, and then
press ENTER.
(e.g. Select SUBWOOFER ON or SUBWOOFER OFF)
5
Press and hold AUDIOSETUP for at least 2 seconds to
return to normal mode.
Notes
• Pressing t returns to the previous Sound menu mode.
• If no operation is performed for 60 seconds, Sound menu mode is
canceled.
Equalizer Presets (FACTORY EQ)
10 typical equalizer settings are preset at the factory for a variety of
musical source material. USER settings are created in the 9BAND P-EQ
mode.
USER FLAT (Initial setting) POPS ROCK NEWS JAZZ
ELEC DANCE HIP HOP EASY LIS COUNTRY
CLASSICAL
Note
• The 9-Band, Parametric EQ is used to create the Factory EQ settings.
*2
*3/*5
VOL LV ADJ
*6
*6
SUBW SYS
POWER IC
*3
*3
TCR
SPATIAL
X-OVER
17
*3
-EN