HDD Damper Ass'y
Make sure the product with black
sheet on the yellow sponge.
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
HDD Thermal Plate
Only the metal plate
attached on this side
Displace the edge by
10 mm and fold back.
15
1
Prepare the metal plate bend.
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
HDD Ass'y
HDD Set Insert after removing the Release Paper of the two-sided tape.
Remove the Release Paper on
the back, close and attach it.
Attach it to HDD closely not to loosen.
Do not bend it at a sharp
angle to put natural R.
To the level of attaching
closely in this range
Longer Direction
(10)
(15)
Attach the HDD Cushion (Yelllow)
9-32
Push and bend
Fold the FPC from the board edge.
When attaching HDD Cushion (Yellow) and HDD Cushion (Black),
set the bending part of the metal plate up.
1
2
1
2
HDD Cushion (Black)
Metal Plate
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion
(Black)
Attach the HDD
Thermal Plate
Remove the Release Paper.