Panasonic CF-30CTQAZ1 TOUGHBOOK Service Manual page 50

9.2.15. Setting the GPS PCB and Bluetooth PCB
1. Fix the GPS BT Angle and GPS PCB using the 2 Screws.
<N11>
2. Connect the Cable to the Connector on GPS PCB.
3. Fix the GPS Ass'y using the 4 Screws. <N12>
4. Connect the Cable to the Connector. (CN25)
Screws <N11>: DFHE5025XA
Screws <N12>: DXQT2+F3FNL
Cautions for Setting GPS ASSY and BT PCB ASSY
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Safety Working
Cabinet Level Standard
Tolerance 0 to 1
Process the wire into the groove.
Ensure that the wrapping Avoid coming over the groove.
direction is right.
Attach the Tape
Fit to the plate squeeze line.
8 1
10 2
Match to the boss center.
Safety Working
Attach the Cable Sheet into
Main Cable and Whip Cable.
Bluetooth Cable
Whip Antenna Cable
Main Antenna Cable
<N12>
<N12>
<N12>
GPS PCB
<N11>
<N11>
to Connector
(CN25)
* Notes:
1. Do not gouge when inserting and removing the plug.
2. Do not damage the coating when handling the cable.
1
Process the wire of whip ANT cable from
LCD to the back from the aperture.
Whip Antenna Cable
Put the Cable along
the Cabinet side and
tape it firmly.
Process the wire to the
back from the aperture.
Bluetooth Cable
Pass the Cable behind
the Cabinet protrusion.
Attach the Cable Sheet into
0 2
Sub Cable and GPS Cable.
0 2
Ensure that the wrapping
direction is right.
Sub Antenna Cable
GPS Antenna Cable
9-28
GPS BT Angle
<N12>
Bluetooth
PCB
Connector(CN25)
Main Antenna
Sub Antenna
Insert the
cable plug.
GPS Antenna
Connect into the coaxial Connector.
Safety Working