Panasonic CF-30CTQAZ1 TOUGHBOOK Service Manual page 43

9.2.11. Setting the PAD PCB
1. Fix the PAD PCB using the 2 Screws. <N4>
2. Attach the TP PCB Screw Sheet.
3. Connect the Cable to the Connector. (CN802)
4. Connect the Cable to the Connector (CN801) and attach
the Tape.
Screws <N4>: DRQT26+D3FKL
Assembly of PAD PCB
* Notes:
1. Apply the load when attaching the parts.
Safety Working
Attach the Touch Pad INS Sheet
Avoid running over the boss and the rib.
0 2
Process the surplus
LED PCB
of FFC to the back.
20N to 30N (2 to 3Kgf)/cm2
Cable Hold Sheet
is installed
Safety Working
Attach the Tape
Fit to the Cabinet line.
Safety Working
Safety Working
Attach the Tape
Fit to the Cabinet line.
PCB Pad
Process the wire targeting the boss.
TP PCB Screw Sheet
Tape
Connector
(CN801)
Pad PCB
Order of fixing
Screw Screw
Insert the boss at an angle to put here close to the Cabinet side.
Process the SP cable between the bosses.
FFC Insertion
PCB Pad is set
Tighten of
Screw
Tighten of
Screw
7 11
7 11
CN Connection After connecting, add the kapton tape.
9-21
<N4>
<N4>
Connector
(CN802)
Safety Working
Attach the Touch Pad
PCB Screw Sheet
Do not insert the Connector at an angle.
0 2
FFC Insertion
Attach the Touch
Pad FFC Fix Tape
0 2
0 2
Attach the
Cable Sheet
Safety Working