Panasonic CF-30CTQAZ1 TOUGHBOOK Service Manual page 34

9.2.3.
Setting the Inverter PCB, TS PCB and LCD Unit
1. Set the LCD Unit to the LCD Front Cabinet in order.
2. Attach the 2 drop holders.
3. Connect the Cable to the Connector. (CN200,CN201)
4. Connect the 3 Cables to the 3 Connectors.
5. Fix the Inverter PCB using the 2 Screws. <N5>
Screws <N5>: DRQT26+D4FKL
Preparation of Inverter
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
2. When handling Inverter-PCB, do not bend or add impact.
Safety Working
Do not touch the Transformer part
when attaching to Inverter Case.
Check the part
number '2148M1'
Board attachment
Match the board edge and the case edge.
Difference: 0.5mm or less
Inverter Shield Case
Prepare Inverter and the Inverter
shield Case Outside for Assysite.
Important Parts
for Safety
Inverter-PCB
Inverter Shield Case is set
Inverter is set,
attach
LCD Drop Holder
LCD Unit
LCD Front Cabinet
Inverter Shield Case Outside
Attach the Inverter Shield Tape
Attach it putting the protrusion mark next to the caution label.
9-12
C
Connector
Connector
(CN201)
(CN200)
TS PCB
LCD Drop
A Holder
B
Inverter PCB
<N5>
C
B <N5>
A
to Connector
(CN200)
Wrap Inverter Shield Tape around Inverter
Shield Case and attach.
Ensure that Inverter Shield Tape does not
run over the edge of Inverter Shield Case.
<Inverter Shield Tapes Attachment Guide>
Protrusion by wrinkles, etc. = 0.2 or less
Air Bubble = 1 cm 2 or less / 1 bubble size