Panasonic CF-30CTQAZ1 TOUGHBOOK Service Manual page 38

Assembly of Power SW
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Tighten of Screw
FPC Power SW is set
Power SW LED
Panel is set
Assembly of Palm Top Cover
Using the pressure jig, Ensure the
loads are applied equally.
Make sure the adhesive materials
are attached closely on the whole
side.
Process the speaker lead wire not to
put inside when applying the load.
Avoid running over the protrusion attached
to the protrusion side of the upper Cabinet.
Attach the Pad
Put to the arrow direction
and attach it.
Protrusion
Battery Pack Insertion Slot
Attach the Battery Slide Sheet (on Battery Cushion)
Avoid air leaking into it. Avoid coming off 4 corners.
Fit to the line.
Attach the DC Gasket
Ensure the upper and lower Flex holes match.
A
B
Ensure that the PAD and the button neck
are attached with adhesive firmly.
Insert FPC into the hole Touch Pad SW Knob
of upper cabinet. Rubber is set
Attach the TP
Bottom Tape
Do not come over
the Pad edge.
Attach the
PWB 6LED
Put to the left and set.
Insert FFC into the hole
LEDX6 Spacer
of upper cabinet.
Sheet is set
FFC 6LED is set
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Attach the Battery Cushion
12 2
25 2
10 1
Order of fixing
Screw Screw Screw
Screw Screw
Note: Separation
Touch Pad SW Knob
In is set
Notes for Separation
Palm Top Cover
is set
Do not attach the
oil on both sides.
Avoid running over!
Attach the Pad WP Sheet
Attach within the range of the
upper Cabinet concave.
Notes:
After attaching, trace around TP,
SW and circumference with finger.
Palm Top
Cover
9-16
Top
Connection Direction
Bottom
Cable Power
Connection
CAB Wall
Connection Direction
Safety Working
Attach the TP
FPC Tape
Match the Cabinet slit
and the tape slit.
Do not run the Cabinet
edge out of the tape slit.
Tighten of
Tighten of
Screw
Tighten of
Screw
Screw
Tighten of
Tighten of
Screw
Screw
Attach the Washer
(See below)
Attach the Washer
Attach it not to cover the hole
of LEDX6 Spacer Sheet.
Palmtop Preparation