Panasonic CF-30CTQAZ1 TOUGHBOOK Service Manual page 35

Assembly of LCD Unit
Attach the TS Controller
Flex Stiffening Plate Edge
Release Paper B
TS Flex Insertion
Attach the Tape
9.2.4.
Setting the LCD Rear Cabinet, Hinge L and R
1. Fix the Hinge L and R using the 2 Screws. <K9-1-4>
2. Set the LCD Latch.
3. Fix the LCD Rear Cabinet using the 4 Screws. <N7> No1 to
No4
4. Fix the left and right LCD Cover Side Cover using the 4
Screws <N7> and 2 Screws. <N13>
5. Fix the 2 Wireless Antenna Corner Cover using the 4
Screws. <N7>
Note:
Tighten the Screws in the numbered order (No1 to No4).
Screws <N2>: DRHM5054XA
Screws <N7>: DRSB26+10HKL
Screws <N13>: DRSB4+10FKL
Screws <K9-1-4>: DRYN4+J10KLT
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Attach the Inverter MIL Shierd
Match to the LCD
edge and attach it.
Clearance : 2 mm or less
0 0.5mm
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm
Release Paper A
1. Insert the TS Flex into the TS Controller, and attach the tape.
2. Remove the Release Paper A and attach the TS Controller.
Release Paper C
(Do not come off the sheet and apply the pressure on the LCD.)
3. Remove the Release Paper B and attach it on the TS Controller.
4. Remove the Release Paper C and attach it on the LCD.
Confirm that the LCD
Cushion is not wrapped.
left LCD Cover
<N7>
Side Cover
<N7>
<N7>
<N7>
No.3
<N7>
Wireless Antenna
Corner Cover
LCD Latch
9-13
LCD Drop Holder Insertion
LCD Front Ass'y
LCD Drop Holder Insertion
<N13>
No.1
<N7>
LCD Rear Cabinet
No.4
<N7>
No.2
<N7>
<N7>
<N7>
<K9-1-4>
right LCD Cover
Hinge L Side Cover
Wireless Antenna
Corner Cover
<K9-1-4>
LCD Front Cabinet
<N13>
<N7>
<N7>
Hinge R