Pe Sensor Holder - Epson L1800 Service Manual

L1800
Make sure that the PW Sensor FFC is routed as shown in
3-154
After replacing or removing the PW Sensor, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
 "Chapter 4
Adjustment
Disassembly And Assembly
Figure
(p.109)"
Removing the Sensors

3.6.4 PE Sensor Holder

1. Remove the Lower Housing / Printer Mechanism. (p.61)
2. Remove the ASF Assy. (p.71)
3. Remove the PE Sensor connector cable from the five tabs on the Release Holder
Assy and the two tabs on the Head Cable Cover.
Head Cable Cover
Release Holder Assy
Figure 3-155. Releasing the Cables
4. Release the tabs that secure the PE Sensor Holder from the notch on the Main
Frame with a flathead screwdriver, and slide the PE Sensor Holder upwards and
then remove it toward you.
Front Side
Tab
Figure 3-156. Removing the PE Sensor Holder
Revision A
PE Sensor connector cable
Tabs
Tabs
PE Sensor Holder
Confidential
99