1.2.2 Electrical Specifications
Description
Rated
voltage
Input voltage range
Rated frequency range
Input frequency range
Power consumption
Power consumption while
in standby mode
1.2.3 Reliability Specifications
Note:
requiring replacement or service.
MTBF (Mean Time Between Failures):
Jam rate:
Feed failure:
Multiple paper feeds:
Paper curl height:
Leading edge bending (1 cm or more):
MTTR (Mean Time To Repair):
Durability:
1.2.4 Environmental Conditions for Operation (Including Imaging Cartridge)
Temperature:
Humidity:
Altitude:
Horizontal placement:
Surrounding space:
1.2.5 Environmental Conditions for Storage and Transportation
(Excluding Imaging Cartridge)
Temperature:
Humidity:
Drop test:
Vibration:
Resistance to atmospheric pressure:
Storage term:
Rev. A
Table 1-5. Electrical Specifications
100-120
90-132
Less than 350 W
3000 power-n hours
1 out of 2,000 sheets or less (excluding multiple-sheet feeding)
1 out of 500 sheets or less
30 mm (1.2 inches) or less
30
minutes or less
5 years or 100,0000 sheets
10 to 35° c (50 to 95° F)
15 to 8570 RH
2,500 m (8,200 feet) or lower
The printer should be installed on a level plane.
3,000 I
or less (must not be exposed to direct sunlight)
UX
The printer should have at least 100 mm of clearance on its
sides and rear.
O to 35° C (32 to 95° F) over full storage term
-20 to 55° C (-4 to 131° F) under extreme conditions
(Extremes are allowable for up to 1/30 of full storage term)
Temperature variation must be 10" C (18° F)/hour or less
30 to 857. RH over full storage term
10 to
RH under extreme conditions
(Extremes are allowable for up to 1/30 of full storage term)
Clear to JIS Z0200-1987 Level 1
Vibration frequency
Acceleration
Acceleration direction 3 direction
More than 613 hPa
24 months (following date of manufacture)
General Description
200 V Version
220-240 VAC
198-264 VAC
50-60 Hz
4 7 - 6 3 tiz
Less than 450 W
Less than 15 W
5 to 100 Hz and 100 to 5 Hz
1-5