Burners And Grids; Control Knobs - CDA HCG 730 Users operating instructions Operating & Installation Instructions Manual

BURNERS AND GRIDS

✓
These parts can be removed and cleaned with appropriate products.
✓
After cleaning, the burners and their flame spreaders must be well dried and correct-
ly replaced.
✓
It is very important to check that the burner flame spreader and the cap have been
correctly positioned. Failure to do so can cause serious problems.
✓
In appliances with electric ignition, check that the electrode "S" (fig. 7) is always
clean to ensure trouble-free sparking.
✓
In the models with safety device, check that the probe "T" (fig. 7) next to each burn-
er is always clean to ensure correct operation of the safety valves.
✓
Both the probe and ignition plug must be very carefully cleaned.
✓
Note: To avoid damage to the electric ignition do not use it when the
burners are not in place.
GAS TAPS
✓
Regular lubrication of the gas taps must only be performed by specialised engineers.
✓
If the gas taps are not working properly call the After-Sales Service.

CONTROL KNOBS

✓
The control knobs may be removed for cleaning but care should be taken not to
damage the seal.
13