Reducing The Maximum Rotation Speed; Entering The Technician-Level Code Number; 6F82Fa Control Operator-Level Parameter List; Status And Error Messages On The V810 And V820 Operating Panels - DURKOPP ADLER 367 Operating Instructions Manual

8.2.4

Reducing the maximum rotation speed

8.2.5

Entering the technician-level code number:

8.3

6F82FA control operator-level parameter list

8.4

Status and error messages on the V810 and V820 operating panels

CAUTION !
The changed parameter values are not saved unless a complete
seam is sewn after leaving programming level, i.e. the pedal is
pushed forwards and then all the way back. If the drive is
switched off straight after leaving programming level, the changes
are lost.
The maximum speed can be reduced to adapt it to particular
applications.
The current maximum speed is constantly shown in the LED display
during sewing. The display shows a 3-digit figure that must be
multiplied by 10 to obtain the actual rotation speed. This value can be
changed during sewing or on a mid-seam halt with the "+" and "-" keys.
The adjustment range lies between the values of parameters F-111
(maximum value) and F-121 (minimum value).
See set-up instructions.
See section 7.4.
See section 7.5.
33