Processor - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

5 Screw in the four CPU heatsink screws. First, tighten all of the screws partially so that the CPU
heatsink remains level. Next, fully tighten one pair of diagonally opposite screws
the remaining pair 2. Tighten firmly to a torque setting of 6 in-lbs.
1
2
6 Connect the CPU heatsink fan connector to the system board.

Processor

Removing the Processor
1 Disconnect power from the system
CPU heatsink (page 96).
2 Raise the processor socket handle fully (the full swing angle of the lever is approximately 135
degrees).
(page 66), remove the access panel
REMOVAL AND REPLACEMENT OF COMPONENTS 99
1 then fully tighten
2
1
(page 71), and remove the