Pci Or Pci Express Installation - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

Table 4-6 PCI Express Compatibility Matrix for xw8200
PCI Express x1
Card
PCI Express x4
Card
PCI Express x8
Card
PCI Express
x16 Card
PCI or PCI Express Removal
1 Disconnect power from the system
workstation on its side with the system board facing up, remove the PCI retainer
remove PCI card support (page 81), if necessary.
2 Lift the PCI levers by first pressing down on them and then out.
3 Lift the PCI card out of the chassis. If removing a PCI Express card, remove the power supply cable
(not illustrated), if required, and move the "hockey stick" lever to release the card and lift it out of the
chassis. Store the card in an anti-static bag.
4 Close the PCI levers.
Figure 4-1

PCI or PCI Express Installation

1 Disconnect power from the system
workstation on its side with the system board facing up, and remove the PCI retainer
2 Lift the PCI levers
3 Remove the PCI slot cover 2.
84 REMOVAL AND REPLACEMENT PROCEDURES
PCI Express x1 Slot PCI Express x4 Slot
(not available)
Y
N
N
N
(page
PCI Removal
(page
1 by first pressing down on them and then out.
PCI Express x8 Slot
(not available)
Y
Y
N
N
66), remove the access panel
Figure 4-1
66), remove the access panel
PCI Express x16 Slot
Y Y
Y N
Y N
N Y
(page 71), lay the
(page 83), and
PCI Express Removal
(page 71), lay the
(page 83).