Bezel Blanks; Hood Sensor (Smart Cover Sensor) - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

2 Rotate the front bezel away

Bezel Blanks

To remove the bezel blanks:
1 Disconnect power from the system
2 Remove the bezel blanks by squeezing in on the tabs and pushing the bezel blanks out.

Hood Sensor (Smart Cover Sensor)

To remove the hood sensor:
1 Disconnect power from the system
workstation on its side with the system board facing up.
2 Disconnect the white 1x3 hood sensor connector from the inline connector attached to the front panel
harness.
3 Slide the hood sensor forward.
72 REMOVAL AND REPLACEMENT PROCEDURES
2 from the chassis and remove the bezel.
1
(page 66) and remove the front bezel
(page 66), remove the access panel
2
(page 71).
(page 71), and lay the